Jun 25, 2018 Leave a message

TV Monitoring Transmission Part

The transmission part is the image signal pathway of the system. In general, the transmission part refers only to the transmission of image signals. However, because of some systems in addition to the image, but also transmit sound signal, at the same time, because of the need to have the control center through the console on cameras, lenses, yuntai, shields, which also contains a control signal in the transmission system transmission, transmission parts, so we said, often referred to as all the sum of the transmission system to transmit signals to form.


As mentioned above, the main content transmitted in the transmission part is the image signal. Therefore, it is very important to study the transmission mode of image signal and related problems in transmission. Of image signal transmission, the key requirement is that after the image signal through the transmission system, does not produce obvious noise and distortion (chroma and luminance signal does not produce significant distortion), to ensure that the original image signal (image signal output from the camera) clarity and grey level no obvious decline, and so on. This requires the transmission system to have good performance in attenuation, introduction of noise, amplitude-frequency characteristics and phase-frequency characteristics.


In terms of transmission mode, video baseband transmission mode has been adopted in most TV monitoring systems up to now. If the camera is far away from the control center, rf transmission or optical fiber transmission is also adopted. For the above different transmission modes, the transmission parts and transmission lines used are quite different.


Send Inquiry

whatsapp

skype

E-mail

Inquiry