The freeze dryer works in three stages:
Freezing
Primary drying (sublimation)
Secondary drying (adsorption)
Proper freeze drying can reduce drying time by 30%.
Stage 1: Freezing Stage
The diagram shows how a freeze dryer works and the ideal freeze drying pressure and freeze drying temperature
This is the most critical stage. Freeze dryers use a variety of methods to freeze the product.
Freezing can be done in a freezer, a freezing bath (shell freezer), or on the shelves of a freeze dryer.
Freeze dryers cool the material below the triple point to ensure that the material sublimates, rather than melts. This preserves the material's physical form.
Freeze dryers are most susceptible to freeze drying larger ice crystals, which can be produced by slow freezing or annealing. However, for biological materials, when the crystals are too large, they may damage the cell wall, resulting in less than ideal freeze drying results. To prevent this, the freezing process is done quickly.
For materials that are prone to precipitation, an annealing process can be used. This process involves rapid freezing and then raising the product temperature to allow the crystals to grow.
Stage 2: Primary Drying (Sublimation)
The second stage is primary drying (sublimation), during which the pressure is reduced and heat is added to the material to sublime the water.
The vacuum of the freeze dryer speeds up the sublimation. The freeze dryer's condenser provides a surface for the water vapor to attach and solidify. The condenser also protects the vacuum pump from the water vapor.
During this stage, about 95% of the water in the material is removed.
Primary drying can be a slow process. Excessive heat can change the structure of the material.
Stage 3: Secondary Drying (Adsorption)
The final stage is secondary drying (adsorption), during which ionically bound water molecules are removed.
By increasing the temperature above that of the primary drying stage, the bonds between the material and the water molecules are broken.
The freeze dried material retains its porous structure.
After the freeze dryer has completed its process, the vacuum can be broken with an inert gas before the material is sealed.
Most materials can be dried to a residual moisture of 1-5%.





