Jun 27, 2018 Leave a message

TV Monitor Display Section

The display part usually consists of several or more monitors (or ordinary TV sets with video input). Its function is to display the transmitted images one by one. In TV monitoring system, especially in the television monitoring system composed of multiple cameras, are generally not corresponding to a video camera to a monitor display, but a few camera image signal with a monitor switch in turn, according to the current popular BSV LCD splicing across the screen, the picture in picture show. One is to save equipment and space. Second, there is no need to display one by one. Because the situation in the monitored place cannot happen at the same time, it can only be displayed at regular intervals (such as seconds, tens of seconds or tens of seconds). When a situation occurs in a monitored place, the signal can be switched to a monitor through a switcher and displayed continuously, and the remote control tracking record can be recorded through the console. Therefore, in a general system, the camera ratio of 4-to-1, 8-to-1, or even 16-to-1 is usually used to set the number of monitors. So far, the proportion of commonly used the camera to monitor for four to one, namely four cameras corresponds to a monitor in turn shows that when the camera sets a lot of, again USES the eight is 16 than one or a set of solutions. In addition, due to the application of image segmentation, in some cameras sets a lot of systems, from several cameras with image segmentation image signal display on a monitor at the same time, also is on a large screen monitor, the screen is divided into several small area is equal, each showing a images from the camera. This greatly saves monitors and makes it easier for operators to see. However, this scheme is not suitable to display too many segmented images on a single monitor at the same time, otherwise it will make some details difficult to see clearly and affect the monitoring effect.

Send Inquiry

whatsapp

skype

E-mail

Inquiry