There Are Many Ways To Freeze Dry
Freeze dryers can be dried in a variety of ways, such as drying, boiling, drying, spray drying, and vacuum drying, but common drying methods are usually carried out at temperatures above 0℃ or higher. The products obtained by drying generally have problems of shrinking size and hardening of the texture. Most of the volatile components are lost, some heat-sensitive substances are denatured and deactivated, and some substances are even oxidized. Therefore, the dried product has a large difference in properties compared with that before drying. The lyophilization process is basically carried out below 0 ℃, that is, in the state where the product is frozen, and only when the residual moisture content of the product is lowered in the later stage, the product is allowed to rise to a temperature above 0℃, but generally does not exceed 40 ℃. Under the vacuum condition, when the water vapor is directly sublimated, the drug remains in the frozen ice shelf, forming a sponge-like porous structure, so the volume after drying is almost unchanged. Before using it again, as soon as you add water for injection, it will dissolve immediately. The freeze dryer has the following advantages over conventional methods:
1. Many heat sensitive substances will not be denatured or inactivated.
2. When drying at low temperatures, some of the volatile components in the material are lost.
3. During the lyophilization process, the growth of microorganisms and the action of enzymes cannot be carried out, so that the original traits can be maintained.
4. Since the drying is carried out in a frozen state, the volume is almost constant, the original structure is maintained, and concentration does not occur.
5. Since the moisture in the material exists in the form of ice crystals after pre-freezing, the inorganic salt-soluble substances originally dissolved in the water are evenly distributed in the material. When the product treated by the freeze dryer is sublimated, the dissolved matter dissolved in the water is precipitated, thereby avoiding the phenomenon that the inorganic salt carried by the internal moisture migration to the surface in the general drying method is precipitated on the surface to cause surface hardening.





