Freeze drying parameters are set as follows:
*Minimum pre freezing temperature: theoretically, the minimum pre freezing temperature must be lower than the co melting point temperature of the product. If the minimum temperature of pre freezing is higher than the co melting point temperature of the product, the product cannot be completely cured, and the liquid will boil during vacuum drying, resulting in freeze-drying failure. Since the co melting point of each product is different, the minimum pre freezing temperature must be determined by experiment according to the type of product, solution concentration and other factors.
*Pre freezing time: the pre freezing time is required to be longer when the product has a large loading capacity and the bottom thickness of the container is not flat, or the product is not directly placed on the board layer of the drying oven.

*Vacuum pumping time: the time when the pre freezing is completed is the time when the vacuum pumping starts. Generally, the vacuum in the box can reach 10Pa within about half an hour. While vacuumizing, open the vacuum valve between the condenser of the drying box, and the vacuum pump and vacuum valve shall be opened until the end of freeze-drying.
*End time of pre freezing: when the pre freezing is completed, the cooling of the shelf layer of the drying box shall be stopped. Generally, the cooling of the heat conduction plate layer shall be stopped while vacuumizing or when the vacuum degree reaches the specified requirements.
*Heating time of drying process: it is generally believed that the time when heating starts is the time when sublimation drying starts (in fact, sublimation starts when vacuum pumping starts).
*Time to control the vacuum in the drying oven: the purpose of vacuum control in the drying oven is to improve the heat transfer in the drying oven. It is usually used in the first stage of drying. The control can be stopped after the sublimation and drying of products.
*Total freeze-drying time: the total freeze-drying time is the pre freezing time plus the sublimation time and the second stage drying time. The total time is determined and the freeze-drying end time is also determined. This time is determined according to the product variety, bottle variety, packing method, loading capacity and machine performance.













