May 16, 2022 Leave a message

Analysis of the freeze-drying stage

2-1 Pre-freezing: Pre-freezing is to solidify the free water of the material, giving the dried product the same shape as before drying, preventing irreversible changes such as foaming, shrinking, concentration, and solute movement during vacuum drying, and reducing temperature The decline causes a decrease in the solubility of the substance and a change in the life characteristics of the substance. Pre-freezing plays a crucial role in the quality of freeze-dried products and two basic requirements must be met: a suitable cooling rate and a suitable final temperature.

The cooling rate depends on the temperature of the cooling source, the number of samples, container volume and surface area, and heat transfer between the sample container and the cold environment. If the cooling rate is too fast, it will cause intracellular ice formation, and if the cooling rate is too slow, the living body will be injured and die. Slow-cooling ice crystals are large, and rapid-cooling ice crystals are small. Quick-frozen products have a uniform appearance and consistent color. Small ice crystals cause less protein denaturation and less coagulation.

Industrial lyophilizer

For products with living substances, quick-frozen mortality is small and freezing time is saved. The final temperature of pre-freezing should be lower than the eutectic point temperature or glass transition temperature of the solution to ensure that the solution of suspended biological material can be completely frozen, otherwise, a small amount of liquid will "boil" to generate bubbles when vacuuming The surface of the product is uneven. For products that are not very demanding, the final temperature of pre-freezing should only be lower than the eutectic point temperature, generally 5 ℃ to 10 ℃ lower than the eutectic point temperature.

2-2 sublimation drying stage

Also known as primary drying, the frozen product is heated in a closed vacuum container, so that the ice crystals sublime into water vapor and escape, thereby dehydrating and drying the product. Drying is gradually pushed inward from the outer surface, and the voids left after the sublimation of the ice crystals become the escape channels for the sublimated water vapor. The first stage of drying is complete when all the ice crystals have been removed, at which point about 90% of the total moisture has been removed. In this process, there is both heat transfer and mass transfer. The heat absorbed by the sublimation of the ice crystal is supplied by the heating plate, and the sublimated water vapor escapes through the gap of the dried layer. However, during the drying process, the remaining part of the material should always be kept in a frozen state. If the temperature is too high, the ice crystals will melt, so the temperature of the frozen layer of the article should be lower than its eutectic temperature. In addition, the temperature of the dried layer cannot exceed the disintegration temperature by heating too fast. The so-called disintegration temperature means that when the temperature reaches a certain value, some dried products will lose their rigidity and have a similar collapse phenomenon. The disintegration of the dried product affects the passage of water vapor from the freeze-dried layer, resulting in partial melting of the product.

2-3 Desorption drying stage

Also called secondary drying. After the end of the first stage, there is still a part of water adsorbed on the capillary walls and polar groups of the dry material, which is not frozen. After the second stage of drying, the residual moisture content in the product is generally between 0.5% and 4%. The desorption time is determined by the variety and shape of the product; the requirements of the residual water content; the performance of the freeze dryer and other factors.

3. Post-processing

Different products have different post-processing methods, and the impact of the environment on the dried products should be minimized. For biological products, it is generally necessary to pack in a vacuum environment or fill the drying chamber with nitrogen and then pack.


Send Inquiry

whatsapp

skype

E-mail

Inquiry