Automatic Water Temperature Machine Stainless Steel

Basic Info

Advantages of Water Temerature Machine

The heat transfer medium of the water temperature machine is water, and the heat transfer medium of the oil temperature machine is oil. Because the specific heat of water is greater than that of oil, the heat conduction effect of the medium of the water temperature machine is much better when the temperature is the same. At the same time, the water temperature machine uses water as the medium and only needs to be connected to tap water, which is easy to use and pollution-free.

Precautions

1. To use the water temperature machine, first connect the water inlet and outlet, and pay special attention to the circulating water inlet and outlet marked by the water temperature machine. General water temperature machines will have a water purification filter at the water inlet. Then turn on the connecting pipe of the mold and turn on the power. Check that all used valves are open.

2. After the preparation work is completed, you can press the power button to turn on the device. At this time, there may be a reverse alarm. The troubleshooting method is to change the power cord. If this is normal, then there may be a media alarm. In order to prevent the safety protection of the water inlet valve from being opened, check whether the circulating water is normal at this time. If it is normal, it indicates that the inlet water pressure is too low. Adjust the pressure switch, but not alarm the circulation pump to start.

3. After the alarm is discharged, the device can set the temperature after a few minutes of circulation, and it can be used normally. If there is a fault alarm during the use, you can see if there is any troubleshooting method in the instruction manual.

4.Since the control parts of the mold temperature machine are composed of sophisticated electrical appliances, it is necessary to ensure that the working environment of the mold temperature machine is clean and avoid dust, so as to extend the service life of the electrical components of the mold temperature machine and reduce the occurrence of failures. If the mold temperature machine is in a dusty area for a long time, it must be maintained regularly. After the power is turned off, use an air gun to blow off the dust. Do not wipe it with a wet towel.

5.It should be noted that when the unit automatically shuts down due to an over-temperature alarm, it must wait until the internal temperature of the unit drops (not less than 3 minutes) and press the reset button to start the unit again.

FAQ

Q1:Can you do the design for us?

A:Sure.We will supply you a proposal as to your specific requirement, and each machine is customized to satisfy customer's need well.

Q2:What about the lead time for mass production?

A:30 work days from date of contract signing (down payment).

Hot Tags: Automatic Water Temperature Machine Stainless Steel, China, factory, suppliers, manufacturers, customized, price, made in China